This parts manual provides detailed information for the Craftsman LT 2000 riding lawn mower with a 42-inch cutting deck. It includes exploded-view diagrams, part numbers, descriptions, and ordering information for the engine, transmission, cutting deck, steering system, electrical components, and other assemblies. Use this manual for identification, maintenance, and replacement of original equipment parts.
This manual is intended for qualified service personnel and owners performing maintenance. Always follow safety precautions.
| Safety Symbol | Meaning |
|---|---|
| WARNING! | Indicates a hazard that could result in injury or death. |
| CAUTION! | Indicates a hazard that could result in property or product damage. |
| NOTE: | Provides helpful information for proper operation or maintenance. |
WARNING! Disconnect spark plug wire before performing any service. Ensure mower is on a level surface and engine is cool.
Locate your model and serial number to ensure correct parts ordering. The label is typically located under the seat or on the frame.
NOTE: Always provide model and serial numbers when ordering parts.
Parts for the engine (typically Briggs & Stratton or Kohler).
Parts for the transaxle, drive belt, and linkage.
CAUTION! Release all tension from belts before removal.
42-inch stamped steel deck with three blades.
| Part Description | Part Number | Qty |
|---|---|---|
| Deck Shell, 42-inch | 123456X | 1 |
| Blade, Standard | 789012A | 3 |
| Blade Spindle Assembly | 345678B | 3 |
| Deck Belt | 901234C | 1 |
| Mandrel & Bearing Kit | 567890D | As needed |
| Deck Hanger & Lift Linkage | 234567E | Set |
| Anti-Scalp Rollers | 890123F | 4 |
Steering wheel, tie rods, drag link, and control levers.
Steering Column Assembly: Includes wheel, shaft, and bushing.
Tie Rod Ends: Left and right.
Drag Link: Connects steering gear to spindle.
Spindles & Kingpins: Front wheel spindles.
Control Lever Assemblies: For deck lift and speed.
Battery, wiring harness, switches, and lights.
WARNING! Disconnect battery before servicing electrical components.
Frame components, body panels, seat, and wheels.
Common bolts, nuts, washers, and pins used throughout the mower.
NOTE: Use grade-specific hardware for replacement.
| Description | Size/Type | Typical Use |
|---|---|---|
| Hex Bolt, Grade 5 | 1/4-20 x 3/4" | General fastening |
| Lock Washer | 1/4" | Under nuts |
| Flat Washer | 1/4" | Spacing |
| Hairpin Cotter | 1/8" x 1-1/2" | Linkage retention |
| Spring Tension Pin | 3/16" x 1" | Pivot points |
Order genuine Craftsman parts to ensure fit and performance.
Online: Visit www.craftsman.com/parts
Phone: 1-888-331-4569
Craftsman Limited Warranty applies to original owner. See separate warranty document for terms.
| Issue | Support Resource |
|---|---|
| Parts Identification | Use this manual; contact dealer with model/serial number. |
| Installation Questions | Refer to service manual; qualified technician recommended. |
| Warranty Claim | Contact selling dealer or 1-888-331-4569. |
| Safety Recall Information | Check www.craftsman.com or contact dealer. |
Service Manual: Sold separately for repair procedures.
Disclaimer: Illustrations may not reflect exact configuration; parts subject to change.