Craftsman T2200 Riding Lawn Mower Manual

The Craftsman T2200 is a 22-horsepower riding lawn mower featuring a Briggs & Stratton engine, hydrostatic transmission, 42-inch cutting deck, electric start, adjustable cutting height, mulching/bagging/side-discharge capabilities, cruise control, headlights, cup holder, and ergonomic high-back seat. Below are key sections for safety, features, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Safety Instructions 3. Assembly & Setup 4. Specifications 5. Controls and Operation 6. Cutting Deck Operation 7. Maintenance Schedule 8. Storage & Winterization 9. Parts & Accessories 10. Warranty Information 11. Troubleshooting

Features at a Glance

Key components: 22 HP Briggs & Stratton engine, Hydrostatic transmission, 42-inch cutting deck, Electric start, Adjustable seat, Cruise control, Headlights.

FeatureDescription
Engine22 HP Briggs & Stratton single-cylinder gasoline engine
TransmissionHydrostatic drive with infinite speed control
Cutting Deck42-inch stamped steel, 3-blade system
Cutting HeightAdjustable from 1.5 to 4 inches in 0.5-inch increments
Starting SystemElectric key start with backup recoil
Speed ControlFoot pedal operation with cruise control
SeatErgonomic high-back with adjustable position
Fuel Capacity2.5 gallons
HeadlightsIntegrated for low-light operation
Discharge OptionsMulch, bag, or side-discharge capable

Safety Instructions

Read all instructions before operating. Always wear appropriate safety gear.

  1. Clear mowing area of debris, toys, and obstacles.
  2. Never carry passengers; operator only.
  3. Do not mow on slopes greater than 15 degrees.
  4. Keep hands and feet away from moving parts.
  5. Always engage parking brake when dismounting.

WARNING! Gasoline is flammable; refuel outdoors with engine off and cool. Keep children and pets away during operation.

Assembly & Setup

Unpack and inspect all parts. Assembly requires basic tools.

  1. Install steering wheel: Align and tighten bolt.
  2. Attach seat: Mount to frame with provided bolts.
  3. Connect battery: Attach red (+) then black (-) terminals.
  4. Install cutting deck: Align with mounting points and secure.
  5. Add engine oil: Use SAE 30 (approx. 48 oz).
  6. Add gasoline: Use fresh unleaded 87 octane minimum.

CAUTION! Ensure all bolts are tightened to specified torque. Check tire pressure (14 PSI).

Specifications

Controls and Operation

Dashboard: Ignition key, Headlight switch, Hour meter, Cup holder. Floor: Forward/reverse pedal, Brake pedal, Deck engagement lever.

Starting Procedure: 1. Sit on seat. 2. Engage parking brake. 3. Set throttle to fast. 4. Turn key to START. 5. Release key to ON.

Driving: Release parking brake. Press forward pedal to move forward; reverse pedal to back up. Use brake to stop.

Shutdown: 1. Engage parking brake. 2. Lower throttle. 3. Turn key to OFF. 4. Remove key.

Cutting Deck Operation

Engage deck only when engine is at full throttle.

  1. Adjust cutting height: Use lever beside seat.
  2. Engage blades: Pull lever up to engage PTO.
  3. Select discharge: Install mulch plug, bagger, or side chute as needed.
  4. Mow in overlapping passes for even cut.
  5. Disengage blades when crossing driveways or obstacles.

Tip: Keep deck clean of grass buildup for optimal performance.

Maintenance Schedule

IntervalTask
Before each useCheck tire pressure, inspect for damage, clear deck
Every 8 hoursCheck engine oil level
Every 25 hoursChange engine oil (first 5 hours), check air filter
Every 50 hoursReplace air filter, check spark plug
Every 100 hoursChange oil filter, grease fittings, check belts
SeasonallySharpen blades, check battery

Blade Sharpening: Remove deck, secure blade, file at original angle. Balance before reinstalling.

Storage & Winterization

Prepare mower for extended storage (especially winter).

  1. Add fuel stabilizer to tank and run engine 5 minutes.
  2. Change engine oil and filter.
  3. Remove spark plug, add 1 oz oil to cylinder, crank slowly, reinstall plug.
  4. Clean entire mower, especially underside of deck.
  5. Store in dry, covered location; disconnect battery.

CAUTION! Never store with gasoline in tank without stabilizer. Drain fuel if storing over 90 days.

Parts & Accessories

Genuine Craftsman parts recommended for optimal performance.

Order parts at www.craftsman.com or call 1-888-331-4569.

Warranty Information

2-Year Limited Warranty: Covers defects in materials/workmanship under normal residential use. Proof of purchase required. Does not cover wear items (blades, belts, tires), damage from misuse, lack of maintenance, or commercial use. For warranty service, contact Craftsman Customer Support at 1-888-331-4569 or visit www.craftsman.com.

Troubleshooting

SymptomPossible CauseCorrective Action
Engine won't startNo fuel, bad spark, dead batteryCheck fuel level; check spark plug; charge/replace battery.
Poor cutting performanceDull blades, low engine speedSharpen/replace blades; run at full throttle.
Excessive vibrationUnbalanced blade, loose partsCheck blade balance; tighten deck bolts.
Loss of powerClogged air filter, old fuelReplace air filter; drain and refill with fresh gas.
Hydrostatic transmission slipsLow fluid, worn beltCheck fluid level; inspect drive belt.
Battery not chargingLoose connections, bad alternatorClean/tighten terminals; test charging system.

Service: For repairs beyond basic maintenance, contact authorized service center at 1-888-331-4569.

Craftsman T2200 Riding Lawn Mower Manual © - All Rights Reserved 2025