Craftsman T2200 Parts Manual

The Craftsman T2200 is a riding lawn mower featuring a 42-inch cutting deck, 18.5 HP Briggs & Stratton engine, 5-speed manual transmission, and electric start. This parts manual provides detailed diagrams, part numbers, and ordering information for maintenance and repair. Below are key sections for identification, engine components, drive system, cutting deck, electrical system, and ordering parts.

Model Identification

Locate your model and serial number for accurate parts identification.

Engine Parts

Parts for the Briggs & Stratton 18.5 HP single-cylinder engine.

1. Air Filter: Replaceable foam and paper element.
2. Spark Plug: Champion RC12YC gap 0.030 inch.
3. Oil Filter: Cartridge type, replace every 100 hours.
4. Fuel Filter: In-line fuel filter.
5. Starter Motor: Electric start with solenoid.

WARNING! Disconnect spark plug wire before servicing engine parts. Use proper tools.

Drive System Parts

Components for the 5-speed manual transmission and drive train.

1. Drive Belt: V-belt for engine to transmission.
2. Transaxle Assembly: 5-speed gearbox with shift linkage.
3. Brake Pads: Disc brake pads for rear wheels.
4. Axle Shafts: Solid rear axles with bearings.
5. Clutch Cable: Manual clutch engagement cable.

CAUTION! Ensure mower is on level surface and parking brake engaged when servicing drive system.

Cutting Deck Parts

• Deck Shell: 42-inch stamped steel housing.
• Blades: High-lift mulching blades (part # 123456X).
• Spindles: Blade spindle assemblies with bearings.
• Deck Belt: PTO belt for deck drive.
• Height Adjustment: Lever and linkage for cutting height.
• Anti-scalp Rollers: Front and rear rollers.
• Deck Wheels: Guide wheels for transport.
• Discharge Chute: Grass discharge chute and deflector.

Electrical System Parts

Components for starting, charging, and safety systems.

Battery: 12V 280CCA lawn tractor battery. Starter Solenoid: Electric start relay. Ignition Switch: Key start with positions. Safety Switches: Seat switch, brake switch, PTO switch. Wiring Harness: Main harness with connectors. Fuses: 20A blade fuse for electrical protection.

Controls & Safety Parts

Operator controls and safety components.

1. Turn off engine and remove key before servicing controls.
2. Steering Wheel: 13-inch diameter with steering column.
3. Brake Pedal: Foot-operated brake with linkage.
4. PTO Lever: Engagement lever for cutting deck.

Tip: Lubricate control linkages periodically for smooth operation.

Frame & Body Parts

Structural components and body parts.

1. Frame: Welded steel main frame.
2. Fenders: Rear fenders over wheels.
3. Seat: High-back seat with suspension.
4. Hood: Engine cover with grille.
5. Footrests: Steel foot platforms.
6. Bumper: Front bumper assembly.

WARNING! Frame components are heavy; use proper lifting equipment.

Maintenance Parts

Common replacement parts for routine maintenance.

Oil: SAE 30 detergent oil (48 oz capacity). Air Filter: Dual-element filter. Spark Plug: As specified. Fuel Filter: Replace annually. Belts: Drive and deck belts. Blades: Sharpen or replace as needed.

Parts Ordering

Order genuine Craftsman parts using model and serial numbers.

Visit www.craftsman.com or contact 1-888-331-4569. Provide model number (917.289XXX) and serial number. Use part numbers from this manual. Shipping available for in-stock parts.

Warranty Information

Limited warranty: 2 years for residential use. Engine warranty: 3 years by Briggs & Stratton. Proof of purchase required. Does not cover normal wear, misuse, or lack of maintenance.

Troubleshooting Parts

Note: Always use genuine Craftsman parts for optimal performance and safety.

Service: 1-888-331-4569; www.craftsman.com