Craftsman T210 User Manual

The Craftsman T210 is a 42-inch riding lawn mower with a 19.5 HP Briggs & Stratton engine, 42-inch stamped steel cutting deck, 6-speed manual transmission, and a 2.5-gallon fuel tank. It features a comfortable high-back seat, easy-to-use controls, and a durable steel frame. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly Instructions 3. First-Time Setup 4. Specifications 5. Controls and Operation 6. Maintenance Schedule 7. Cutting Deck Adjustment 8. Safety Features 9. Storage & Winterization 10. Warranty Information 11. Troubleshooting

Features at a Glance

Key components: 19.5 HP Briggs & Stratton engine, 42-inch cutting deck, 6-speed manual transmission, high-back seat, and durable steel frame.

Feature	Description
Engine	19.5 HP Briggs & Stratton, single-cylinder, OHV
Cutting Deck	42-inch stamped steel, 3-blade system
Transmission	6-speed manual, gear-driven
Fuel Tank	2.5-gallon capacity
Seat	High-back, adjustable for comfort
Cutting Height	Adjustable from 1.5 to 4 inches
Drive System	Rear-wheel drive
Turning Radius	18 inches
Weight	Approximately 450 lbs
Warranty	2-year limited warranty

Assembly Instructions

Unpack and inspect all parts. Assemble on a flat, stable surface.

Attach the steering wheel: Align and secure with provided hardware.
Install the seat: Bolt seat to frame using included bolts and washers.
Attach the cutting deck: Lower deck under mower and secure with pins and belts.
Connect the battery: Attach positive and negative terminals.
Add engine oil and fuel: Use SAE 30 oil and unleaded gasoline.

WARNING! Mower is heavy; use assistance for lifting. Ensure all bolts are tightened securely.

First-Time Setup

Before first use, complete the following steps.

Check oil level: Ensure oil is at the full mark on the dipstick.
Fill fuel tank: Use fresh unleaded gasoline.
Adjust seat position: Set for comfortable reach to controls.
Test controls: Verify steering, brake, and clutch operation.
Engage blades: Test cutting deck engagement in a safe area.

CAUTION! Keep hands and feet away from moving parts during testing.

Specifications

Engine: 19.5 HP Briggs & Stratton, single-cylinder, OHV.
Cutting Width: 42 inches.
Transmission: 6-speed manual, gear-driven.
Fuel Capacity: 2.5 gallons.
Cutting Height: Adjustable from 1.5 to 4 inches.
Drive Type: Rear-wheel drive.
Turning Radius: 18 inches.
Weight: Approximately 450 lbs.
Warranty: 2-year limited warranty.

Controls and Operation

Key controls: Ignition key, throttle, choke, gear shift, brake, clutch, and blade engagement lever.

Starting Procedure: Sit on seat, set parking brake, disengage blades, turn key to start.

Driving: Press clutch, select gear, release clutch slowly. Adjust speed with throttle. Stopping: Press brake, disengage blades, turn key off.

Maintenance Schedule

Regular maintenance ensures optimal performance and longevity.

Check oil before each use: Change every 50 hours or annually.
Replace air filter: Every 25 hours or as needed.
Sharpen blades: Every 25 hours or when cutting quality declines.
Check tire pressure: Monthly, maintain 12-14 PSI.
Lubricate moving parts: Every 10 hours of operation.

Tip: Refer to the engine manual for specific engine maintenance.

Cutting Deck Adjustment

Adjust cutting height to suit lawn conditions.

Park on level surface: Engage parking brake.
Locate adjustment lever: On right side of mower.
Select height: Move lever to desired setting (1.5 to 4 inches).
Test cut: Mow a small area to ensure even cutting.

WARNING! Always disengage blades and turn off engine before adjusting deck.

Safety Features

Operator Presence System: Engine stops if operator leaves seat with blades engaged. Blade Brake Clutch: Stops blades within 3 seconds of disengagement. Parking Brake: Locks rear wheels to prevent rolling.

Storage & Winterization

Prepare mower for long-term storage, especially over winter.

Clean mower: Remove grass clippings and debris.
Stabilize fuel: Add fuel stabilizer or drain tank.
Change oil: Replace with fresh oil.
Remove battery: Store in a cool, dry place.
Cover mower: Use a breathable cover to protect from dust.

CAUTION! Store in a dry, well-ventilated area away from open flames.

Warranty Information

Craftsman T210 includes a 2-year limited warranty covering defects in materials and workmanship. Warranty does not cover normal wear, misuse, or lack of maintenance. For warranty claims, contact Craftsman customer service at 1-888-331-4569 or visit www.craftsman.com. Keep your receipt as proof of purchase.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	Empty fuel tank, dead battery	Refill fuel tank; charge or replace battery.
Poor cutting quality	Dull blades, low engine speed	Sharpen or replace blades; adjust throttle to full speed.
Excessive vibration	Loose blade, unbalanced deck	Tighten blade bolts; check deck for damage.
Loss of power	Clogged air filter, old fuel	Clean or replace air filter; drain and replace fuel.
Hard to steer	Low tire pressure, worn parts	Inflate tires to 12-14 PSI; inspect steering linkage.

Reset: Turn key off and wait 30 seconds before restarting if engine overheats.

Service: 1-888-331-4569; www.craftsman.com