Craftsman T110 Riding Mower Manual

The Craftsman T110 is a 42-inch deck riding lawn mower featuring a 19.5 HP Briggs & Stratton engine, hydrostatic transmission, 6-speed shift-on-the-go gear drive, electric start, adjustable cutting height (1.5-4 inches), mulching capability, and a 2.5-gallon fuel tank. Designed for residential use on medium to large lawns. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly & Setup 3. Controls and Operation 4. Specifications 5. Maintenance Schedule 6. Cutting Deck Adjustment 7. Storage & Winterization 8. Safety Features 9. Parts & Accessories 10. Warranty Information 11. Troubleshooting

Features at a Glance

Key components: 19.5 HP Briggs & Stratton engine, 42-inch steel cutting deck, Hydrostatic transmission, Electric start, Adjustable seat, Mulch kit compatible.

Feature	Description
Engine	19.5 HP Briggs & Stratton, single-cylinder, OHV
Cutting Width	42 inches
Transmission	Hydrostatic, single-speed forward/reverse
Fuel Tank	2.5 gallons (unleaded gasoline)
Cutting Height	Adjustable 1.5 to 4 inches (6 positions)
Start Type	Electric key start
Deck Engagement	Manual PTO lever
Brake System	Disc brake on transmission
Seat	High-back, adjustable fore/aft
Tires	Front: 15x6.00-6, Rear: 20x10.00-8

Assembly & Setup

Unpack and inspect all parts. Assembly requires basic tools.

Install steering wheel: Align and tighten bolt.
Attach seat: Mount using provided bolts and washers.
Install battery: Connect red (+) then black (-) terminals.
Attach cutting deck: Secure with pins and belts per manual.
Check tire pressure: Front 14 PSI, Rear 10 PSI.
Add oil and fuel: Use SAE 30 oil (48 oz) and unleaded gasoline.

WARNING! Always disconnect spark plug wire during assembly. Ensure all bolts are tightened securely.

Controls and Operation

Familiarize yourself with controls before starting.

Starting: Sit on seat, set parking brake, engage PTO to OFF, turn key to START.
Driving: Release parking brake, press brake pedal to disengage transmission lock, use forward/reverse pedals.
Mowing: Engage PTO lever, adjust throttle to full, select cutting height.
Stopping: Disengage PTO, idle engine for 30 seconds, turn key OFF, set parking brake.

CAUTION! Never operate on slopes greater than 15 degrees. Keep hands and feet away from moving parts.

Specifications

Model: Craftsman T110
Engine: 19.5 HP Briggs & Stratton (540cc)
Cutting Deck: 42-inch stamped steel
Transmission: Hydrostatic, infinite forward/reverse speeds
Fuel Capacity: 2.5 gallons
Cutting Height Range: 1.5 - 4 inches
Turning Radius: 18 inches
Weight: 478 lbs (approx.)
Warranty: 2-year limited

Maintenance Schedule

Regular maintenance ensures longevity and performance.

Interval	Task
Before each use	Check tire pressure, oil level, fuel level
Every 8 hours	Check deck belts for wear, clean deck
Every 25 hours	Change oil (first change at 8 hours), check air filter
Every 50 hours	Replace air filter, check spark plug
Every 100 hours	Replace spark plug, change oil filter
Seasonally	Sharpen blades, lubricate fittings, check battery

Note: Always refer to manual for specific part numbers and procedures.

Cutting Deck Adjustment

Proper deck leveling ensures even cut.

Park on level surface, set cutting height to middle position.
Measure blade tip height at all four corners of deck.
Adjust lift rods to level deck (front slightly lower than rear).
Recheck measurements after adjustment.

Tip: Deck should be level side-to-side, front 1/4-inch lower than rear for proper discharge.

Storage & Winterization

Prepare mower for extended storage (especially winter).

Clean entire mower, especially under deck.
Change oil and run engine briefly to circulate.
Add fuel stabilizer to tank, run for 5 minutes.
Disconnect battery, store in cool dry place.
Store in covered, dry location.

WARNING! Never store with fuel in tank without stabilizer. Drain fuel if storing over 30 days.

Safety Features

Operator Presence System (OPS): Engine stops if operator leaves seat with PTO engaged. Parking Brake: Must be set to start engine. Blade Brake Clutch: Stops blades within 3 seconds when disengaged.

Parts & Accessories

Genuine Craftsman parts recommended: Blades (part # 942-0743), Air Filter (part # 42-050), Oil Filter (part # 49-850), Mulch Kit (part # 190-385). Available at Sears or authorized dealers.

Warranty Information

2-year limited warranty for residential use. Covers defects in materials/workmanship. Does not cover normal wear, misuse, or lack of maintenance. For warranty service, contact 1-888-331-4569 or visit www.craftsman.com. Keep original receipt as proof of purchase.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	Dead battery, clogged fuel line, bad spark plug	Charge/replace battery, check fuel flow, replace spark plug.
Poor cutting performance	Dull blades, deck not level, low engine speed	Sharpen blades, level deck, check throttle setting.
Excessive vibration	Damaged blade, loose pulley, debris in deck	Inspect/replace blade, tighten components, clean deck.
Loss of power	Dirty air filter, old fuel, clogged carburetor	Replace air filter, use fresh fuel, clean carburetor.
Hydrostatic transmission issues	Low fluid, drive belt worn	Check fluid level, inspect/replace drive belt.

Service: For technical support: 1-888-331-4569, www.craftsman.com